Agilent Technologies B1500A Instrukcja Obsługi Pobierz pdf (Strona 563)

100

101

Agilent B1500A/B1505A Programming Guide, Edition 11 5-9

Error Messages

Operation Error

245 Specify a higher measurement range to QSR.

Too large offset current was measured. Specify the next higher

measurement range to the QSR command.

246 QSV mode value must be 1 or 3.

The mode values available for the QSV command are 1 (single linear)

and 3 (double linear). Set one of the available values.

247 Dedicated channel must be specified by QSO.

Specify the dedicated channel to the QSO command. It must be the

channel other than the measurement channel set by the MM13

command or the sweep output channel set by the QSV command.

253 Program memory is full.

Maximum of 2000 programs or 40000 commands can be stored in the

program memory. See “ST” on page 4-188.

254 Invalid input for a memory program.

The GPIB GET command (TRIGGER statement in HP BASIC) and an

external trigger input are not allowed in a memory program (between

the ST and END commands).

255 Maximum nesting level is eight.

Nesting (one program calling another) of a memory program must be

eight levels or less.

260 Data output buffer is full.

Maximum 34034 measurement data items can be stored in the data

output buffer.

270 Search source channel must be set.

Before triggering the search measurement or sending the LSSV, LSSI,

BSSV, or BSSI command to set the synchronous search source, send

the LSV, LSI, BSV, or BSI command to set the primary search source.

271 Search monitor channel must be set.

Before triggering the search measurement, send the LGV, LGI, BGV, or

BGI command to set the search monitor channel.

1 2 ... 558 559 560 561 562 563 564 565 566 567 568 ... 597 598

Komentarze do niniejszej Instrukcji

Brak uwag

Agilent Technologies B1500A Instrukcja Obsługi Strona 563

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Agilent Technologies B1500A