Agilent Technologies 8133A Instrukcja Obsługi Pobierz pdf (Strona 39)

Testing Performance 3

16800 Series Portable Logic Analyzers Service Guide 39

Connect the Test Equipment

Connect the Logic Analyzer Pod to the 8133A Pulse Generator

1 Connect a Transition Time Converter (if required—see

Table 7, “Recommended Test Equipment,” on page 19) to

the 8133A pulse generator’s Channel 2 OUTPUT, Channel

2 OUTPUT

, and Channel 1 OUTPUT.

2 Connect the SMA/Flying Lead test connector (see “To

Assemble the SMA/Flying Lead Test Connectors" on

page 28) with the 50 ohm terminator to the Transition

Time Converter at the 8133A pulse generator Channel 1

OUTPUT. (If Transition Time Converters are not required,

connect the SMA/Flying Lead test connector directly to

the pulse generator output.)

3 Connect the two SMA/Flying Lead test connectors without

50 ohm terminators to the Transition Time Converters at

the 8133A pulse generator Channel 2 OUTPUT and

Channel 2 OUTPUT

. (If Transition Time Converters are

not required, connect the SMA/Flying Lead test

connectors directly to the pulse generator outputs.)

4 Connect an E5383A Flying Lead Probe Set to Pod 1 of the

logic analyzer.

5 Connect the E5383A Flying Lead Probe Set’s CLK lead to

the pin strip of the SMA/Flying Lead connector at the

8133A pulse generator’s Channel 1 OUTPUT.

ground lead

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 187 188

Brak uwag

Agilent Technologies 8133A Instrukcja Obsługi Strona 39