
To use the Test Automation Module
Now, the setup for the test is complete. In an actual application, this
completes the administration portion. You can now proceed to use it for
testing, just like an operator is going to use it for testing.
1 Press Setup .
2 Press the Sequence Menu softkey.
3 Press the Reset softkey to return to step number 1.
The live signal is tested against the mask created during the set up process.
A blinking PASS indicator appears in the lower-left corner of the display.
4 Press the orange ground button on the probe and hold it.
This grounds the input and creates a failure condition. A blinking FAIL
indicator appears in the lower-left corner of the display. Also, a fail-zone
indicator bar just above the FAIL indicator shows where the failure occurs.
5 Release the orange ground button.
Quick Start
To use the Test Automation Module
14
Komentarze do niniejszej Instrukcji