Agilent Technologies Ininiium 9000 Dokumentacja Pobierz pdf (Strona 129)

Chapter 6: Replacing Assemblies

To remove and replace the backlight inverter board

129

Figure 6-25

Disconnect the cables from the backlight inverter board and remove the two T10 screws (shown

in Figure 6-26). You may need to temporarily remove the touch screen cable (with the blue

connector) in order to remove and replace the inverter board.

Figure 6-26

When you replace the inverter board, tighten the screws to 5 in-lbs and be sure to align the

board over the pems.

Main oscilloscope chassis (lying on

its rear panel)

Front chassis after you lift it up

Inverter board

Disconnect these cables

Remove these two T10 screws

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 165 166

Brak uwag

Agilent Technologies Ininiium 9000 Dokumentacja Strona 129