Agilent Technologies Ininiium 9000 Dokumentacja Pobierz pdf (Strona 121)

Chapter 6: Replacing Assemblies

To remove and replace the front panel bezzle, front panel keyboard, touchscreen, and Autoprobe board

121

Figure 6-10

There are two tabs on the edge closest to the touchscreen that need to be disengaged. To

disengage the one near the top of the oscilloscope, look down the edge from the top and press

in on the tab (meaning press straight towards the bottom of the oscilloscope) with a flathead

screwdriver while pulling up on the plastic keyboard cover / keyboard. The plastic piece and

keyboard will not come all the way off because you need to repeat this procedure for the bottom

tab (look along the inner edge from the bottom, push in on the bottom tab (meaning push

towards the top of the oscilloscope), and then pull up on the plastic keyboard cover / front

panel keyboard). Figure 6-11 shows a picture of performing this procedure on the upper tab.

Figure 6-11

Disengage three tabs

Top of the oscilloscope

Plastic piece

covering

front panel

keyboard

Top inner tab that

you need to disengage

Push flathead screwdriver

straight back (towards

the bottom of the

oscilloscope) and pull up like this picture shows

to disengage this tab.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 165 166

Brak uwag

Agilent Technologies Ininiium 9000 Dokumentacja Strona 121