Agilent Technologies InfiniiVision 6000 Series Instrukcja Obsługi Pobierz pdf (Strona 489)

Commands by Subsystem 5

Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 489

:TRIGger:SWEep

(see page 798)

Command Syntax

:TRIGger:SWEep <sweep>

<sweep> ::= {AUTO | NORMal}

The :TRIGger:SWEep command selects the trigger sweep mode.

When AUTO sweep mode is selected, a baseline is displayed in the absence

of a signal. If a signal is present but the oscilloscope is not triggered, the

unsynchronized signal is displayed instead of a baseline.

When NORMal sweep mode is selected and no trigger is present, the

instrument does not sweep, and the data acquired on the previous trigger

remains on the screen.

Query Syntax

:TRIGger:SWEep?

The :TRIGger:SWEep? query returns the current trigger sweep mode.

Return Format

<sweep> ::= current trigger sweep mode

See Also • "Introduction to :TRIGger Commands" on page 479

This feature is called "Mode" on the instrument's front panel.

Agilent Technologies InfiniiVision 6000 Series Instrukcja Obsługi Strona 489