Agilent Technologies PSG Instrukcja Obsługi Pobierz pdf (Strona 148)

Programming the Status Register System

Status Groups

Chapter 3134

Data Questionable Calibration Condition Register

The Data Questionable Calibration Condition Register continuously monitors the calibration

status of the signal generator. Condition registers are read only.

Data Questionable Calibration Transition Filters (negative and positive)

The Data Questionable Calibration Transition Filters specify which type of bit state changes

in the condition register set corresponding bits in the event register. Changes can be positive

(0 to 1) or negative (1 to 0).

Data Questionable Calibration Event Register

The Data Questionable Calibration Event Register latches transition events from the

condition register as specified by the transition filters. Event registers are destructive

read-only. Reading data from an event register clears the content of that register.

Table 3-10 Data Questionable Calibration Condition Register Bits

Bit Description

DCFM/DCΦM Zero Failure. A 1 in this bit indicates that the DCFM/DCΦM zero calibration

routine has failed. This is a critical error. The output of the source has no validity until the

condition of this bit is 0.

1−14 Unused. These bits are always set to 0.

15 Always 0.

Query: STATus:QUEStionable:CALibration:CONDition?

Response: The decimal sum of the bits set to 1

Commands:

STATus:QUEStionable:CALibration:NTRansition <value> (negative), or

STATus:QUEStionable:CALibration:PTRansition <value> (positive), where

<value> is the sum of the decimal values of the bits you want to enable.

Queries:

STATus:QUEStionable:CALibration:NTRansition?

STATus:QUEStionable:CALibration:PTRansition?

Query: STATus:QUEStionable:CALibration[:EVENt]?

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 361 362

Brak uwag

Agilent Technologies PSG Instrukcja Obsługi Strona 148