Agilent Technologies E8247C PSG CW Instrukcja Użytkownika

Agilent E8247C/57CPSG CW and Analog Signal GeneratorsData SheetAll specifications and characteristics apply over a 0 to 55° C range (unlessotherwise s

1019 For fc< 2 MHz AM is usable but not specified. AM specifications apply with ALC on, and envelope peaks < maximum specified power. For instru

11Standard Option 1E6≥ 500 MHz ≥ 500 MHz > 3.2 GHzto ≤ 3.2 GHz to ≤ 3.2 GHzOn/off ratio 80 dB typical 80 dB 80 dBRise/fall times (Tr, Tf ) 100 ns

12Modes Free-run, triggered, triggered with delay, doublet, and gated. Triggered with delay, doublet, and gated require external trigger source.Perio

13Interfaces GPIB (IEEE-488.2,1987) with listen and talk, RS-232,and 10BaseT LAN interface.Control languages SCPI version 1997.0. Also will emulate m

14RF output Nominal output impedance 50 Ω.For 20 GHz models Precision APC-3.5 male, or Type-N with Option 1ED.For 40 GHz models Precision 2.4 mm male;

15Stop sweep In/Out Open-collector, TTL-compatible input/output. In ramp sweep operation, provides low level (nominally 0 V) during sweep retrace and

16www.agilent.com/find/emailupdatesGet the latest information on the productsand applications you select.Agilent Technologies’ Test andMeasurement Sup

2Agilent Microwave PSG CW/Analog Signal Generators optionsFrequency range (required option)Option-520 250 kHz to 20 GHzOption-540 250 kHz to 40 GHzSt

3Range1Option 520 250 kHz to 20 GHzOption 540 250 kHz to 40 GHzResolutionCW 0.001 HzAll Sweep modes 0.01 HzAccuracy Aging rate ± temperature effects

4Operating modes Step sweep of frequency or amplitude or both (Start to stop)List sweep of frequency or amplitude or both (Arbitrary list)Sweep range

5Power9(dBm)Frequency range Standard Option 1EA20 GHz Models250 kHz to 3.2 GHz –20 to +13 –20 to +16250 kHz to 3.2 GHz (with Option 1E6) –20 to +13

6Level accuracy with step attenuator12(dB)Frequency> +10 dBm +10 to –10 dBm –10 to –70 dBm –70 to –90 dBm –90 to –110 dBm250 kHz to 2 GHz±0.6 ±0.6

7Harmonics14(dBc at +10 dBm or maximum specified output power, whichever is lower)< 1 MHz –28 dBc typical1 MHz to 2 GHz –28 dBc> 2 GHz to 20 G

8Option UNR: Enhanced SSB phase noise (CW)Offset from carrier (dBc/Hz)Frequency 100 Hz 1 kHz 10 kHz 100 kHzspec (typ) spec (typ) spec (typ) spec

9Typical RMS Jitter17:Standard Carrier frequency SONET/SDH RMS jitter Unit Intervals Time (fs)Data Rates bandwidth (µUI)155 MHz 155 MB/s 100 Hz to