Agilent Technologies Cell Phone S GSM Instrukcja Użytkownika Pobierz pdf (Strona 315)

100

101

8-19

Instrument BASIC

Entering and Editing Programs

Line-by-line Entry and Editing

Program lines in the Agilent 8922M/S’s RAM can be entered and edited one line at

a time from your computer using the PROG command -

OUTPUT Addr;”PROG:EXEC ‘<program line/command> ’”

with <program/command> representing any command or program line you want to

enter.

For example, to enter or change line 20 of a program to ‘20 A=3.14’, you would

enter the following command on your computer

OUTPUT Addr;”PROG:EXEC ‘20 A=3.14 ’”

Quoted strings, such as those used in PRINT commands, must use double quotes.

Example -

OUTPUT Addr;”PROG:EXEC ‘30 PRINT “”TEST”” ’”

Using a Terminal A connected terminal, or PC using a terminal emulator, is used to enter characters

directly into the Agilent 8922M/S IBASIC Controller’s command line.

Editing a program line requires you to re-enter the full line with corrections.

Conﬁguring your terminal/PC for this operation is explained in this chapter, ‘Serial

Port Conﬁguration for Programming” on page 8-6.

Entering Commands

When program lines or commands are entered, you press the ENTER key on your

terminal to execute the command. For example, to LIST a program in RAM you

would type LIST,

This differs from using the Cursor Control knob to enter characters where you select

‘Done’ to execute the command.

ENTER

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 380 381

Komentarze do niniejszej Instrukcji

Brak uwag

Agilent Technologies Cell Phone S GSM Instrukcja Użytkownika Strona 315

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Agilent Technologies Cell Phone S GSM