Agilent Technologies E6640A EXM Instrukcja Obsługi Pobierz pdf (Strona 316)

316 Chapter 19

TD-SCDMA Programming Commands

Code Domain Power (CDP)

TD-SCDMA Programming Commands

Code Domain Power (CDP)

This section provides the remote control SCPI commands for the TD-SCDMA Code Domain Power

(CDP) measurement from within the List Sequencer. This measurement is available only if you have the

TD-SCDMA measurement application licensed on the test set.

For more detailed information about the CDP measurement, refer to the online help associated with the

TD-SCDMA measurement application, which is also available in PDF format (“User’s and

Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.

You can also refer to the measurement guide for the X-series TD-SCDMA measurement application,

which is available on the Agilent website, www.agilent.com/find/mxa.

Code Domain Power (CDP) measurement SCPI commands

There is a set of SCPI commands available to program the TD-SCDMA CDP measurement when it is

used in the TD-SCDMA mode. To set up the TD-SCDMA measurements from within the Sequence

Analyzer mode you need to prefix the SCPI commands with LSEQuencer:TDSCdma. For example, the

[:SENSe]:CDPower part of the CDP SCPI commands are replaced with

[:SENSe]:LSEQuencer:TDSCdma:CDPower.

The following commands are used to set up the CDP measurement.

[:SENSe]:LSEQuencer:TDSCdma:CDPower:RINTerval

[:SENSe]:LSEQuencer:TDSCdma:CDPower:ANALysis:SUBFrame

[:SENSe]:LSEQuencer:TDSCdma:CDPower:SCLength

[:SENSe]:LSEQuencer:TDSCdma:CDPower:CDCHannel

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 339 340

Brak uwag

Agilent Technologies E6640A EXM Instrukcja Obsługi Strona 316