Agilent Technologies E6640A EXM Instrukcja Obsługi Pobierz pdf (Strona 129)

100

101

Chapter 9 129

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

5: Expected Power at DUT Output

For a description of this parameter, see “5: Expected Power at DUT Output” on page 34. The

parameter-specific commands are described below.

SCPI Command

To set the expected power as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

EPOWer <amp>

[:SENSe]:LSEQuencer:ACQuire{1:512}:ASTep{1:1000}:SETup:

EPOWer?

To set the expected power as an array:

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:EPOWer

<amp>,<amp>,<amp>,…

[:SENSe]:LSEQuencer:ACQuire{1:512}:LIST:SETup:EPOWer?

The array form of the command is used to make a different setting for each

analysis interval in the acquisition (the number of array values must match the

number of analysis intervals; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:SET:MPA:EPOW 20dBm

:LSEQ:ACQ2:SET:MPA:EPOW?

:LSEQ:LIST:SET:MPA:EPOW 0,20dBm,10dBm

:LSEQ:LIST:SET:MPA:EPOW?

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 339 340

Komentarze do niniejszej Instrukcji

Brak uwag

Agilent Technologies E6640A EXM Instrukcja Obsługi Strona 129

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Multimetry Agilent Technologies E6640A EXM