Agilent Technologies 8000 Series Podręcznik Użytkownika Pobierz pdf (Strona 22)

Setting Up the Oscilloscope

To connect oscilloscope probes

1-17

To connect oscilloscope probes

There are optional Infiniium oscilloscope probes, such as the 1130 and 1160

series probes, that connect to the oscilloscope differently than other

oscilloscope probes. Use the following steps to connect these snap-on probes

to the oscilloscope.

1 Attach the probe connector to the desired oscilloscope channel or

trigger input. Push it straight on until it latches into place.

Figure 1-6

Attaching the Probe Connector

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 128 129

Infiniium 1
Infiniium Oscilloscopes 2
In This Book 3
Contents 4
Figure 1-1 9
Setting Up the Oscilloscope 10
To inspect package contents 10
Figure 1-2 10
Ω) or 20:1 (1 kΩ), .25 pf 12
To connect power 16
Table 1-4 18
Power Cords 18
Figure 1-5 21
Attaching the Probe Connector 22
Figure 1-7 23
To connect SMA Cables 25
To connect the digital probe 26
Digital probe lead set 27
Probe Tip Isolation Network 28
40-pin Connector Pinout 29
Figure 1-15 31
To turn on the oscilloscope 32
To turn off the oscilloscope 33
Calibration 34
To clean the oscilloscope 40
Working in Comfort 42
Introduction 43
Mice and Other Input Devices 45
Using the Front Panel 48
Front Panel 49
Horizontal Controls 50
Trigger Controls 50
Vertical Controls 50
To clear the waveform display 54
Channel Key 55
Use this key to turn 55
Digital Channels Key 56
Use this key to turn digital 56
Vertical offset knob— 58
Figure 3-8 59
Delayed again 61
Figure 3-12 63
To use the markers 64
To use the quick measurements 65
Using the Graphical Interface 67
Graphical User Interface 68
Tab Display Area 71
Figure 3-19 76
Figure 3-20 77
1 Click on a menu bar item 78
Figure 3-22 80
Figure 3-23 81
To print the screen 84
To change waveform brightness 85
To turn a channel on or off 86
To adjust the vertical offset 87
...or click on the 88
Click to access the 88
To adjust vertical scaling 89
To access the channel setup 90
To adjust sweep speed 92
To adjust horizontal position 93
Figure 3-36 96
1 Turn on the markers 97
Figure 3-37 98
Using the Oscilloscope 100
Figure 3-38 100
To access the trigger setup 101
To set an edge trigger 102
To set dialog box preferences 103
Figure 3-41 104
Figure 3-42 105
Figure 3-43 107
Figure 3-44 108
To calibrate the touch screen 109
Figure 3-45 110
Figure 4-1 115
Access Methods 116
Figure 4-2 116
Topic Types 118
Figure 4-4 119
3-26, 3-27, 3-42 122

Komentarze do niniejszej Instrukcji

Brak uwag

Agilent Technologies 8000 Series Podręcznik Użytkownika Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Agilent Technologies 8000 Series