Agilent Technologies C-Size VXIbus Systems Instrukcja Użytkownika Pobierz pdf (Strona 68)

EPC7-1 : Set the EPC7 as Slot 0 Device

The Agilent RADI-EPC7 is shipped from the factory to be the VXI Slot 0

Controller and System Controller. Therefore, if you are using the EPC7 as

the slot 0 controller, you do not have to change any switches or jumpers.

This figure illustrates the jumper positions and definitions.

Slot 0 functionality is used during operation for the following purposes:

– locate where modules are installed in the mainframe.

– manage data flow across the VXIbus backplane busses

– provide the system clock (SYSCLK - 16 MHz)

See Appendix A, "Terms and Definitions," for additional information on the

slot 0 device. See the Agilent RADI-EPC7 documentation for information

on other EPC7 Configurations.

NOTE Once the EPC7 is set as the slot 0 device, it must then be installed in slots 0

and 1 of the mainframe.

Jumpers installed to set

EPC7 as Slot 0 Controller

and System Controller

Figure 2-39. Setting EPC7 for Slot 0 Controller

2-50 Setting Up an Embedded RADI-EPC7 Computer C-Size Configuration Guide

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 177 178

Brak uwag

Agilent Technologies C-Size VXIbus Systems Instrukcja Użytkownika Strona 68